Product ID:ULTRAJET (ES670,ES1200,ES1270,ES1275)
MSDS Date:01/01/1991
FSC:7045
NIIN:00D003036
MSDS Number: BQXZG

Emergency Phone: 404-424-4888,800-424-9300(CHEMTREC)

Info Phone: 404-424-4888

Preparer: M.WATKINS

Cage: 2M589

Telephone: 770-424-4888/800-645-5244

Cage: 2M589

CHLORODIFLUOROMETHANE

CAS: 75-45-6

RTECS: PA6390000

Fraction By Weight: 100%

OSHA PEL 1000 PPM

ACGIH TLV: 1000 PPM; 9293

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES AND SKIN: LIQUID CONTACT CAN
CAUSE FROSTBITE. INHALATION: VAPOR IS HEAVIER THAN AIR AND CAN
CAUSE SUFFOCATION. BREATHING HIGH CONCENTRATIONS OF VAPOR MAY CAUSE
LIGHT-HEADEDNESS, GIDDINESS, SHORTN ESS OF BREATH, AND MAY LEAD TO
NARCOSIS, CARDIAC IRREGULARITIES, UNCONSCIOUSNESS, DEATH.
INGESTION:ORAL TOXICITY IS LOW.
Effects of Overexposure:EYES: TEMPORARY DISCOMFORT, FROSTBITE. SKIN:
IRRITATION, REDDENING, DEFATTING, FROSTBITE. INHALATION:
SUFFOCATION, LIGHT-HEADEDNESS, GIDDINESS, SHORTNESS OF BREATH,
NARCOSIS, CARDIAC IRREGULARITIES, U NCONSCIOUSNESS, DEATH. NAUSEA,
VOMITING, IRRITATION OF MOUTH AND GI TRACT.
Medical Cond Aggravated by Exposure:PERSONS WITH KNOWN HISTORY OF HEART
DISEASE OR IRREGULARITIES OF HEARTBEAT MAY BE AT INCREASED RISK
FROM EXPOSURE TO THIS PRODUCT.

First Aid:EYES: FLUSH WITH LARGE AMOUNTS OF WATER. GET MEDICAL
ATTENTION. SKIN: FLUSH WITH LARGE AMOUNTS OF WATER. IF IRRITATION
PERSISTS GET MEDICAL ATTENTION. INHALATION: MOVE TO FRESH AIR. IF
NOT BREATHING, GIVE CPR. IF BREATHING DIFFICULT, GIVE OXYGEN. GET
MEDICAL ATTENTION. DO NOT GIVE EPINEPHRINE OR SIMILAR DRUGS.
INGESTION: NOT LIKELY TO BE HAZARDOUS. DO NOT INDUCE VOMITING. GET
MEDICAL ATTENTION.

Flash Point Method:TOC
Flash Point:NONE
Lower Limits:NONFLAMMABLE
Upper Limits:NONFLAMMABLE
Extinguishing Media:NONFLAMMABLE
Fire Fighting Procedures:OTHER BURNING MATERIAL MAY CAUSE ULTRAJET TO
BURN WEAKLY. EXTINGUISHERS FOR OTHER BURNING MATERIAL IN AREA IS
SUFFICIENT TO STOP BURNING. SCBA MAY BE REQUIRED.
Unusual Fire/Explosion Hazard:PRESSURIZED AEROSOL CONTAINERS MAY VENT,
RUPTURE, OR EXPLODE AND ADD TO FLYING AND FALLING DEBRIS.
DECOMPOSITION MAY OCCUR.

Spill Release Procedures:VENTILATE AREA. REMOVE OPEN FLAMES OR OTHER
SOURCES OF IGNITION. COLLECT SPILLED PRODUCT WITH ABSORBENT
MATERIAL AND PLACE IN CLOSED STEEL DRUMS FOR PROPER DISPOSAL. KEEP
UPWIND, EVACUATE ENCLOSED SPA CE AND LOW AREAS UNTIL HEAVY VAPORS
AREDISPERSED.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN A CLEAN, COOL, DRY, WELL
VENTILATED AREA AWAY FROM SOURCES OF HEAT, DIRECT SUNLIGHT, OR
WHERE TEMPERATURES MAY EXCEED 120F. ROTATE STOCK.
Other Precautions:PROTECT CONTAINERS FROM PHYSICAL DAMAGE.

Respiratory Protection:NONE REQUIRED FOR ADEQUATELY VENTED WORK
SITUATIONS. FOR ACCIDENTAL OR NON-VENTILATED SITUATIONS, USE A
SELF- CONTAINED BREATHING APPARATUS OR SUPPLIED-AIR RESPIRATOR,
APPROVED BY NIOSH.
Ventilation:LOCAL EXHAUST SHOULD BE USED WHEN LARGE AMOUNTS ARE
RELEASED. USE MECHANICAL (GENERAL) VENTILATION IN LOW PLACES.
Protective Gloves:BUTYL GLOVES.
Eye Protection:CHEMICAL SPLASH GOGGLES.
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:WASH AFTER HANDLING AND BEFORE EATING,
DRINKING, OR SMOKING. DO NOT SMOKE IN AREA WHILE PRODUCT IS IN USE.
Supplemental Safety and Health

Boiling Pt:B.P. Text:-41F,-41C
Vapor Pres:138 PSIG
Vapor Density:2.98
Spec Gravity:1.19
Evaporation Rate & Reference:<1 (BUTYL ACETATE=1)
Solubility in Water:0.30% BY WT
Appearance and Odor:COLORLESS, LIQUID AEROSOL. SLIGHT ETHEREAL ODOR.
Percent Volatiles by Volume:100

Stability Indicator/Materials to Avoid:YES
ALKALI OR ALKALINE EARTH METALS-POWERED ALUMINUM, ZINC, BERYLLIUM, OR
MAGNESIUM.
Stability Condition to Avoid:AVOID SPRAYING NEAR OPEN FLAMES OR RED HOT
SURFACES. DO NOT HEAT AEROSOL CONTAINERS ABOVE 120F/49C.
Hazardous Decomposition Products:DECOMPOSED BY HIGH TEMPERATURES (OPEN
FLAMES) FORMING HYDROCHLORIC AND HYDROFLUORIC ACIDS AND POSSIBLY
CARBONYL HALIDES.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:DO NOT PUNCTURE OR INCINERATE AEROSOL CANS.
DISPOSE OF WASTE IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.